Secure the sensor 3 with the larger nylon ties 7 at the appropriate place and in the right direction.ĥ on a spoke of the front wheel so that the surface of the magnet will face the sensor. Mount sensor and adjust the gap between the magnet and the sensor.
Cateye bike computer reset manual#
Please don’t throw away this manual, Keep the manual at a place easily accessible.
Cateye bike computer reset install#
Please read these instructions carefully before attempting to install and use your CAT EYE MITY 8 computer so that you understand the functions of this product. The position of the magnet and the sensor.ġ Bracket 2 Cord 3 Sensor 4 Sensor Rubber Padĥ Magnet 6 Bracket Rubber Pad 7 Nylon Ties (5) When the computer does not indicate the speed, check Rotate the front wheel gently and see if the computer indicates the running speed. Turn the handlebar from left to right without pulling the wire. To re turn to normal display, press the MODE button or start your bicycle again to cancel the Power Saving function. When you need to remove the computer, slide forward the computer with the lever pushed simultaneously.Īllow enough wire clearance in the area marked with an Slide the computer into the bracket until you hear the click sound The contact points are automatically closed. Put the rubber pad 6 on the bracket 1 and secure the bracket on the handle bar with the screw. Secure the cord on the front fork with the nylon ties (smaller ones) 7 and coil it around the brake cable that leads to the handle bar. Rotate the sensor on the front fork to adjust the gap between the sensor and the magnet 5 within 5 mm, and secure it with the nylon ties. Mount the sensor 3 at the appropri- ate position so that the center of the magnet 5 will align with the marked line on the sensor when the wheel is rotated. The computer is combined with the following parts. Installation of the Computer on Your Bike Tire size is usually shown on the sidewall of tires. You need to know the tire circumference (L cm) be- forehand. This Cateye Velo Wireless cycling computer features a front fork speed sensor and will fit almost any handlebar or stem with the generous 22mm to 32mm. When you want to start the odometer from zero,.Used odometer, keep pressing the MODE button for two seconds and input the reading. When you want to input the reading of the currently.Select the measurement unit, kilometer or mile, by pushing the MODE button. (the screen will show the time measurement in this state) Setting is completed by pushing the SET button. You can easily set it by referring to the chart shown (the odometer starts from the reading you inputted) Stable measurement when you use this system for the first time and every time the battery is replaced. Push three buttons (MODE, START/ STOP and SET) at the same time. (For 1st use or after replacing the battery)
Don’t use thinner, benzene or alcohol to wipe the surface of theĬomputer.Avoid unnecessary prolonged exposure to the sun.Keep batteries out of reach of small children.Periodically check to insure they are mounted securely and the screws are not loosen. Be sure to securely mount the magnet, the sensor, and theīracket on your bicycle. Two buttons on the back are used to either reset it or scroll through the data pages.Pay attention to the road or trail! Do not be distracted by the.
0 kommentar(er)
